Acta Chim. Sinica ›› 2019, Vol. 77 ›› Issue (8): 758-764.DOI: 10.6023/A19040129 Previous Articles    

Special Issue: 多孔材料:金属有机框架(MOF)

Article

双金属MOF-74-CoMn催化剂的制备及其CO选择性催化还原技术应用

武卓敏a, 石勇a, 李春艳b, 牛丹阳a, 楚奇a, 熊巍a, 李新勇a   

  1. a 大连理工大学环境学院 工业生态与环境工程教育部重点实验室和精细化工国家重点实验室 大连 116024;
    b 大连理工大学材料学院 大连 116024
  • 投稿日期:2019-04-11 发布日期:2019-07-08
  • 通讯作者: 石勇 E-mail:sys-99@163.com
  • 基金资助:

    国家自然科学基金面上资助项目(No.21677022).

Synthesis of Bimetallic MOF-74-CoMn Catalyst and Its Application in Selective Catalytic Reduction of NO with CO

Wu Zhuomina, Shi Yonga, Li Chunyanb, Niu Danyanga, Chu Qia, Xiong Weia, Li Xinyonga   

  1. a Key Laboratory of Industrial Ecology and Environmental Engineering and State Key Laboratory of Fine Chemicals, School of Environmental Science and Technology, Dalian University of Technology, Dalian 116024, China;
    b School of Materials, Dalian University of Technology, Dalian 116024, China
  • Received:2019-04-11 Published:2019-07-08
  • Contact: 10.6023/A19040129 E-mail:sys-99@163.com
  • Supported by:

    Project supported by the National Natural Science Foundation of China (No. 21677022).

A series of bimetallic MOF-74-CoMn catalysts with different metal ratios have been successfully synthesized by hydrothermal method and applied in selective catalytic reduction of NO with CO (CO-SCR). The experimental procedure for the preparation of MOF-74-CoMn catalyst is as follows:The reaction solution was a 3.28 mmol mixture of Co(NO3)2·6H2O and Mn(NO3)2·6H2O, 1.09 mmol 2,5-dihydroxyterephthalic acid (H4DOBDC) and 90 mL ethanol-DMF-water. The molar ratio of mixture (Co/Mn) was 1:0, 1:1, 1:2, 1:4, 1:6, respectively. The reactant solution was ultrasonically stired for 30 min until homogeneous. Then, the mixture was transferred into a 100 mL Teflon autoclave then kept in an oven at 100℃ for 24 h. Finally, after purified with DMF and methanol, the products were dried in a vacuum oven at 80℃ for 24 h to obtain a purple MOF-74-CoMn catalyst, which were stored in vacuum or an inert atmosphere. The prepared sample is referred to as MOF-74-Co1Mnx, where x represents a molar ratio of Co to Mn is 1:x (x=0, 1, 2, 4, 6). The SCR catalytic activities were carried out in a fixed-bed flow reactor in gas stream. The experimental results show that the NOx conversion rate of bimetallic MOF-74-CoMn catalyst is generally higher than that of single metal MOF-74-Co catalyst, and their reaction temperature window is wider. Especially, MOF-74-Co1Mn2 exhibited the highest selective catalytic reduction of NO with CO (CO-SCR) performance which is close to 100% with a temperature range from 175 to 275℃. Further, the bimetallic MOFs catalysts were characterized by X-ray powder diffraction (XRD), thermogravimetric analysis (TGA), scanning electron microscopy (SEM), N2 adsorption/desorption, X-ray photoelectron spectroscopy (XPS), Hydrogen-temperature programed reduction (H2-TPR) and Infrared spectroscopy (FTIR) techniques. The results showed that the synergistic effect between Co and Mn metals could obviously promote the formation of unsaturated metal sites and oxygen vacancies, thereby promoting their catalytic reduction efficiency of selective catalytic reduction of NO with CO (CO-SCR).

Key words: bimetallic organic framework material, MOF-74-CoMn, selective catalytic reduction, carbon monoxide, nitrogen oxide, hydrothermal method