化学学报 ›› 2013, Vol. 71 ›› Issue (12): 1639-1646.DOI: 10.6023/A13070794 上一篇    下一篇

研究论文

In3+共掺杂诱导NaY0.95-xYb0.03Er0.02F4相转变与上转换发光增强研究

俞瀚a, 黄清明a,b, 曹文兵a, 张新奇b, 俞建长a   

  1. a 福州大学材料科学与工程学院 福州 350108;
    b 福州大学测试中心 福州 350002
  • 投稿日期:2013-07-27 发布日期:2013-10-12
  • 通讯作者: 俞瀚 E-mail:fjfzyh@fzu.edu.cn
  • 基金资助:

    项目受福建省自然科学基金(No. 2013J05027)与福建省中青年教师教育科研项目(No. JA13050)资助.

Phase Transition Induction and Upconversion Luminescence Enhancement of NaY0.95-x Yb0.03Er0.02F4 by In3+ Codoping

Yu Hana, Huang Qingminga,b, Cao Wenbinga, Zhang Xinqib, Yu Jianchanga   

  1. a College of Materials Science and Engineering, Fuzhou University, Fuzhou 350108;
    b Instrumental Analysis & Measurement Center, Fuzhou University, Fuzhou 350002
  • Received:2013-07-27 Published:2013-10-12
  • Supported by:

    Project supported by the Fujian Province Natural Science Fund (No. 2013J05027) and the Fujian Province Education-Science Project for Middle-aged and Young Teachers (No. JA13050)

引入In3+作为新的掺杂离子通过水热法合成了In3+与Er3+,Yb3+共掺杂的NaYF4上转换发光材料. 通过XRD表征及Rietveld精修,SEM以及TEM研究了In掺杂引起的NaYF4形貌与晶体结构的变化. 通过发射光谱与发光衰减曲线表征了掺杂NaYF4的上转换发光性能,以研究晶体微观结构与上转换发光性能之间的关系. 结果表明随着In掺杂量的增加,立方相NaYF4的晶格畸变不断增强且发生由立方相向六方相的转变. 对于六方相NaYF4,其上转换发光强度随着In含量的提高不断增强并当In含量为3%时达到最大值. 该研究结果可以有助于设计与合成具有优良上转换发光性能的材料.

关键词: 上转换, In3+掺杂, 相转变, 发光, 氟钇酸钠

In3+ was taken as a new dopant to codope NaYF4 with Er3+ and Yb3+ by hydrothermal synthesis in this manuscript. How to improve phase transition of NaYF4 from cubic to hexagonal and how to improve upconversion luminescence performance of hexagonal NaYF4 are both important problems because hexagonal NaYF4 is the most efficient matrix material for upconversion. Considering these two problems, we report the study of crystal structure and upconversion emission of In3+-codoped NaYF4 to discover phase transition mechanism and upconversion luminescence properties changed with different In3+ codoping concentration. NaY0.92Yb0.03Er0.02F4 was tridoped with 0, 2, 4, 6, 8 and 10 mol% In3+ at 170 ℃ for 8 h in order to study phase transition of NaYF4. The other group of samples was prepared by the same procedure except In3+codoping concentration was replaced as 0, 1, 2, 3, 4 and 5 mol% and the reaction proceeded at 190 ℃ for 12 h in order to obtain pure hexagonal NaYF4 for study of its upconversion luminescence. The change of morphologies and crystal structural transition caused by In3+ codoping was explored by XRD, Rietveld refinement, SEM and TEM analysis methods, while the upconversion luminescence was characterized by emission spectra and luminescence decay curves, for the relationship between crystal microstructure and luminescence properties to be discussed in our investigation. On the basis of these characterizations we found that with rising of the In3+ codoping concentration, the phase transition of NaYF4 from cubic to hexagonal was improved. The intensity of upconversion luminescence was also found to be increased to the maximum when 3 mol% In3+ was codoped into hexagonal NaYF4. The analysis and discussion discovered that the phase transition of NaYF4 was correlated with the lattice distortion of cubic NaYF4 improved by In3+ codoping. The intensity of upconversion luminescence was proved to be increased by the asymmetry of the local crystal field changed with the In3+ codoping concentration. This investigation may be helpful for design and synthesis of other functional materials.

Key words: upconversion, In3+ codoping, phase transition, luminescence, NaYF4