Acta Chimica Sinica ›› 2026, Vol. 84 ›› Issue (6): 888-896.DOI: 10.6023/A26030067 Previous Articles     Next Articles

Article

低共熔溶剂固锂与4-叔丁基吡啶减量策略提升正式钙钛矿太阳能电池稳定性

熊相明a,b, 张林a,b, 徐文军a,b, 唐景航a,b, 杨英a,b,*()   

  1. a 中南大学冶金与环境学院 长沙 410083
    b 有色金属资源循环利用湖南省重点实验室 长沙 410083
  • 投稿日期:2026-03-04 发布日期:2026-05-15
  • 基金资助:
    国家重点研发计划项目(2023YFC3906103)

Deep Eutectic Solvent-Assisted Lithium Immobilization and 4-Tert -butyl pyridine-Less Regulation Strategy for Enhancing the Stability of Conventional Perovskite Solar Cells

Xiangming Xionga,b, Lin Zhanga,b, Wenjun Xua,b, Jinghang Tanga,b, Ying Yanga,b,*()   

  1. a School of Metallurgy and Environment, Central South University, Changsha 410083, China
    b Hunan Key Laboratory of Nonferrous Metal Resources Recycling, Changsha 410083, China
  • Received:2026-03-04 Published:2026-05-15
  • Contact: E-mail: muyicaoyang@csu.edu.cn; Tel.: 0731-88877863
  • Supported by:
    National Key R&D Program of China(2023YFC3906103)

Conventional perovskite solar cells (PSCs) exhibit broad commercial prospects in the photovoltaic field due to their high power conversion efficiency (PCE) and low fabrication cost. However, the limited carrier transport efficiency of the hole transport layer (HTL) and insufficient long-term stability remain critical bottlenecks hindering their industrialization. The traditional doping system of 4-tert-butyl pyridine (tBP)/lithium bis(trifluoromethanesulfonyl)imide (LiTFSI) has inherent drawbacks: tBP is volatile and Li⁺ tends to migrate, which easily induce interfacial degradation and device performance decay. Herein, we propose a doping strategy using a deep eutectic solvent (DES) composed of choline chloride (ChCl), urea, and ethylene glycol (EG) with a molar ratio of 1∶2∶1 at a concentration of 1 mg•mL−1 into the Spiro-OMeTAD precursor solution to optimize the Spiro-OMeTAD-based HTL, combined with regulating the tBP/LiTFSI molar ratio to 2∶1 for tBP reduction. Driven by hydrogen bonding and coordination interactions, the DES achieves a synergistic mechanism of “lithium immobilization-defect passivation-molecular network enhancement”: specifically, the carbonyl groups (C=O) of urea in DES coordinate with Li⁺ to suppress thermal-induced migration, the amino groups (-NH2) form hydrogen bonds with TFSI- to promote LiTFSI dissociation, and the hydroxyl groups (-OH) of EG assist in stabilizing the coordination network; meanwhile, DES molecules passivate uncoordinated Pb2+ on the perovskite surface to reduce non-radiative recombination, and enhance the π-π stacking of Spiro-OMeTAD to optimize carrier transport channels and increase its glass transition temperature (Tg) for improved thermal stability. Benefiting from this strategy, the fabricated conventional PSCs achieve a champion PCE of 21.15%. Moreover, the devices exhibit significantly improved long-term stability under various environmental conditions: 97% of the initial PCE is retained after 1000 h of dark storage at 25 ℃ in N2 atmosphere (vs. 88% for the control device); the T80 lifetime (time to retain 80% of the initial efficiency) reaches 120 h at 85 ℃ in N2 atmosphere (vs. 48 h for the control device); and 80% of the initial PCE is maintained after 500 h of storage at 25 ℃ and 30%~40% relative humidity in air (vs. 60% for the control device). This work provides an effective “low-dose, high-compatibility, long-stability” strategy for HTL doping engineering, which is of great significance for promoting the industrialization of PSCs.

Key words: perovskite solar cells (PSCs), Spiro-OMeTAD, deep eutectic solvent (DES), Li+ migration, stability